PinMode()

void pinMode (uint8_t pin, uint8_t mode) </pre> 設置引腳模式

配置引腳為輸出或輸出模式.

參數:

• pin 引腳編號
• mode: INPUT, OUTPUT, 或 INPUT_PULLUP.

例子:

int ledPin = 13;                 // LED connected to digital pin 13

void setup()
{
  pinMode(ledPin, OUTPUT);      // sets the digital pin as output
}

void loop()
{
  digitalWrite(ledPin, HIGH);   // sets the LED on
  delay(1000);                  // waits for a second
  digitalWrite(ledPin, LOW);    // sets the LED off
  delay(1000);                  // waits for a second
}

注解:

• 模擬引腳也可以當作數字引腳使用, 編號為14(對應模擬引腳0)到19(對應模擬引腳5).